Fit & sizing

The gap between the armrests matters more than the advertised seat width

Started by pixelcruncher • November 19, 2026 • 9 replies
pixelcruncher
pixelcruncher November 18, 2026 at 6:38 PM

I've been shopping for a scooter for my father and keep running into the same problem. The listed seat width is almost always 18 or 20 inches, but when we actually sat him in a few, the armrests were the thing that made or broke the fit. One 18-inch model was fine, another felt like a vice. I'm starting to think the armrest gap is the number people should be comparing, not just the seat spec. Anyone else noticed this? Is there a standard way to measure it before buying?

wheelsandtea
wheelsandtea November 18, 2026 at 11:08 PM

Yes, this is real. Seat width tells you the cushion, but armrests are often adjustable or fixed at a width that has nothing to do with the seat. Some are hinged and flip up, some have a knob, and some are welded. If the armrests don't move, the seat width is only half the story.

graygables
graygables November 18, 2026 at 11:11 PM

Measure across the inside of the armrests at the point where his forearms rest, not at the front edge. The front can flare out. Also measure with him wearing the jacket he'd normally wear. We had a scooter that fit in the showroom and then didn't fit in winter.

pixelcruncher
pixelcruncher November 18, 2026 at 11:15 PM

That's a good point about the jacket. Did you end up changing the armrests or the whole scooter?

graygables
graygables November 19, 2026 at 1:21 AM

Whole scooter. The armrests on that one were fixed and the manufacturer didn't offer a wider kit. It was cheaper to swap than to modify.

bramblepatch
bramblepatch November 19, 2026 at 1:51 AM

I work in a mobility shop and this is the single most common return reason. People order online by seat width and then the armrests dig into thei hips or the gap is too wide and they feel loose. We always ask for an inside-armrest measurement before recommending anything.

kettle_on
kettle_on November 19, 2026 at 2:36 AM

Does anyone know if the Pride Go-Go armrests can be widened? Mine are close but not quite.

bramblepatch
bramblepatch November 19, 2026 at 4:07 AM

Some of the Go-Go models have a bolt under the seat frame that lets you shift the armrest bracket outward a bit, but it's only about an inch of adjustment and not on every yeear. Worth checking the manual for your specific model year.

ossuary_rose
ossuary_rose November 19, 2026 at 5:36 AM

The armrest gap also changes how easy it is to get on and off. Too narrow and you can't swing your legs, too wide and there's nothing to push against when standing. It's a balance, not just a maximum.

foggybottom
foggybottom November 19, 2026 at 8:54 AM

I've never seen armrest gap listed on a spec shee. Is that just me? Seat width, yes, but not the gap.

Post a reply

Find Your
Perfect Scooter šŸ”„