corrosion

The connector pins were corroded after years of outdoor use

Started by rustybolt_99 • November 18, 2026 • 11 replies
rustybolt_99
rustybolt_99 November 18, 2026 at 6:43 AM

So I've had my scooter for about six years, mostly stored in the shed or under a tarp. Lately it's been cutting out randomly, and I finally traced it to the main battery connector – the pins are green and crusty. Has anyone successfully cleaned these off, or is it just a matter of replacing the whole plug? I'm not great with electrics, so any advice appreciated.

cobweb_carl
cobweb_carl November 18, 2026 at 7:43 AM

Green crust means copper corrosion.You can try white vinegar on a cotton bud, but honestly if it’s that bad the pins are probably pitted. I’d just replace the connector pair. Cheap enough on eBay.

jane_of_all_trades
jane_of_all_trades November 18, 2026 at 8:01 AM

Vinegar stinks but it works. Rinse with distilled water after and dry totally. Then smear a tiny bit of dielectric grease on the new pins to stop it happening again.

scooter_skeptic
scooter_skeptic November 18, 2026 at 8:16 AM

Six years outdoors under a tarp? That tarp probably trapped condensation. Corrosion is inevitable. Replace the connector and keep the scooter indoors from now on.

rustybolt_99
rustybolt_99 November 18, 2026 at 9:13 AM

Indoors isn’t really an option – no garage, and the house is tiny. But I could bring the battery pack inside at least. The connector itself is on the scooter frame though.

grumpy_grandpa
grumpy_grandpa November 18, 2026 at 11:45 AM

Just cut the plug off and use a choc block.Not pretty but it works. Did that on my old Invacare and it ran for another three years.

sparky_sue
sparky_sue November 18, 2026 at 11:56 AM

Choc block is a fire risk outdoors, mate. Don’t do that. Proper waterproof connector is like a fiver. Get one with a rubber boot.

jane_of_all_trades
jane_of_all_trades November 18, 2026 at 12:03 PM

Agree with sparky_sue.Also check the wire itself – corrosion can wick up the strands under the insulation. If the wire is stiff or green further back, you need to cut it back to clean copper before crimping.

cobweb_carl
cobweb_carl November 18, 2026 at 12:29 PM

If you do cut back, us adhesive-lined heatshrink over the crimp. That’s the only way to keep damp out.

grumpy_grandpa
grumpy_grandpa November 18, 2026 at 12:41 PM

Fine, fine. But don’t come crying to me when your fancy waterproof plug still corrodes because you left it under a wet tarp.

scooter_skeptic
scooter_skeptic November 18, 2026 at 12:43 PM

Honestly the whole “stored outdoors” thing is the root cause. i’ve seen scooters kept in damp sheds that eat through connectors in two years. You’re fighting a losing battle unless you improve storage.

rustybolt_99
rustybolt_99 November 18, 2026 at 1:09 PM

Thanks all. I’ll try cleaning first just to confirm it’s the connection, then order a waterproof replacement pair. The tip about cutting back the wire is helpful – hadn’t thought of that.

Post a reply

Find Your
Perfect Scooter 🔥